Hi all!

First of all, apologies for disappearing for a while. I ran into some unexpected challenges while moving and rebuilding my workspace, but everything is finally done and I’m back on track! I’ll also be making up for the lost time. 🙂

This is Part II of the Screaming Cactuses series! Printing and assembly are pretty much the same as with the previous model.

For full multicolor details (teeth + eyebrows), a multicolor printer is required. All other parts can be printed separately, including the eyes, tongue, uvula, and planters.

The planters are hollow and can also be used as small stash containers.

Printing Instructions:

Both cactuses require supports (tree supports recommended) All other parts print without supports The uvula is optional — print it with a brim since it’s extremely small

Notes:

• If you have a multicolor printer, I recommend printing the pre-colored eyes instead of assembling them manually
• If not, you can print the eyes in separate parts, but keep in mind they are very small, so slight scaling adjustments (around 2%–3%) may be needed depending on your printer
• The uvula is optional and tiny -use a small amount of glue and pliers for easier attachment
• Scaling the model up or down should not cause any issues