This is a super last-minute design that was requested several times. Although I made a middle finger bunny 2 years ago, the hidden surprise part is new this time.

I’ll be reducing the number of middle-finger designs over the next few months - there have been quite a few lately 😅

Printing:

The bunny and all of its parts are multipart, so no AMS is required. The small paw is quite tiny, so I’ve included a pre-colored 3MF file, as assembling it can be a bit tricky.

The body and egg parts require supports - I recommend using tree/organic supports.

Notes:

The egg has two bottom options:

One clean version One with a slot for the tiny middle finger paw

If any of the multipart pieces don’t fit properly, try adjusting the scale in 2% increments.