3D prints and gifts

sign in to my membership plan and get commercial license to sell the prints (not the files) And if you commit for 6 months and use code: commercial10 than you have a 10% discount for 3 months. If you commit for 8 months and use code: commercial20 than you have a 20% discount for 4 months.

Select a membership plan

Monthly billing

Annual billing

Model is included in this plan
Available now

10% off

commercial selling prints

$9.00

/ month

when billed annually

This membership gives you the right to print and sell all of my designs. The commercial license does not permit you to sell my files.

Immediate access. Cancel anytime.

Model is included in this plan
Available now

10% off

V.I.P.

$13.50

/ month

when billed annually

As a V.I.P. you get commercial license to sell the prints (not the files) and also get to join the discord channel.

Immediate access. Cancel anytime.

Mushroom lamp

3D prints and gifts

Remix Model

Social

Become a member

Makes

29 Likes8 DownloadsJune 14, 2023

Total width 16,5cm. Total height 17cm. Dimensions of the place to put the socket in are: 8cm high, 4,7cm radius. The parts are orientated as the should be printed. There is a hole that i covered with one layer where the wire comes in the stem, i did this so it can be printed without supports and the one layer is easy to remove. The hat will need a bit of support. When everything is in place you just screw the hat on the stem and it is done. You like to sell the prints? Just subscribe to my membership plan.