Total width 16,5cm. Total height 17cm. Dimensions of the place to put the socket in are: 8cm high, 4,7cm radius. The parts are orientated as the should be printed. There is a hole that i covered with one layer where the wire comes in the stem, i did this so it can be printed without supports and the one layer is easy to remove. The hat will need a bit of support. When everything is in place you just screw the hat on the stem and it is done. You like to sell the prints? Just subscribe to my membership plan.
Categories:
29 Likes8 DownloadsJune 14, 2023