Pretty simple. This is a two-piece cover for IIIDMax. I usually buy their PLA+ 10 rolls for $120 deal so I have quite a few of these boxes lying around. They're nice boxes and you can store things in them…. Except for the hole they put there so you can see the color. This plugs that.
Use the your multicolor tool to make a label, label maker… Or if a permanent marker. Your choice.
This is a quick an easy print. I print at the .28 layer height and it's 17 minutes for both pieces (after the 6 minute calibration so 30 minutes for just one pair by themselves) of the cover and 11g of filament.
Thin cover to conserve filament and save time, so if you go to remove it, it might break. Be careful.
IIIDMax Affiliate Link If you're interested in both cheap, good filament and also supporting me since I get a 5% cut from purchases: https://bit.ly/3QwZvgh
Or use code “Worsty”
.Step Files Provided
Steal it, slap your logo on it, sell it. Hard for me to care. Just, if you can, link back to me.