Yet another bag clip. Here is a useful bag clip that tightly closes a folded plastic bag or similar. This design is printed as a single part.
My design does not use much filament and comes in three sizes. The three clip sizes included with clamping sizes of 60, 90 and 120mm, respectively.
For heavy and wide clamping, I've included two versions of the 120mm clamp, 10 and 12mm wide. The 12mm wide clamp still flexes, but flexes less (my favourite).
I experimented printing the clips in PETG and PLA+. Both gave what appeared to be quite pliable and usable clips. I did notice that the PLA+ got more brittle whilst clamping a bag in the freezer and breaking. In the end, it comes down to your intended use case. PETG being the most robust of the two filaments I tried.
My prints are made with eSUN PETG 1.75mm Orange filament, with 0.2mm layer height and 15% infill on a Bambu X1 Carbon printer. No supports required.
I hope that you can find this print useful, too.
Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings.
For more of my models, see my main uploads site: https://makerworld.com/en/u/3687936443