Here is a shampoo/soap holder I made for the wife. It hangs on the edge of a clawfoot tub. Holds your stuff while soaking in the tub! I made a custom design for the front panel just for my wife but I have deleted it here so You can make your own custom one of a kind message or design. This should be made from PETG only of course. The model is separated into 4 parts for easier printing and requires simply assembly with CA glue or similar bonding. The pins and corresponding holes are there to aid in alignment only and will not secure the assembly together. There is a .3mm tolerance between the pins and holes already in place. Adjust as needed. Be mindful that the model is designed to be assembled front and back first, then the sides. Put glue on all mating surfaces and then use a pair of sliding clamps to hold it all together as it dries. Do not use instant bond CA glue. Use one with at minimum a 30 second bond time or even 4-5min to allow for you to position the parts in time. Check their fitment BEFORE using the glue. File if need to make them fit smoothly.