_THE ACTUAL FILES ARE LOCATED IN THE ZIP FOLDERS. _ This is the Gear Rhombo & Gear Rhombo Junior (Jr.) (the Spirit of Mini Gear Sphere). This is totally redesigned from the Gear Sphere by TNTBA. With this purchase you get:
- 3MF and STL files for all parts (Gear Rhombo & Gear Rhombo Jr)
- X1 Carbon & A1 Mini layouts
- License to print and sell this model - Forever!
For Gear Rhombo: TRY IT BEFORE YOU BUY IT Print time is approximately 6 hours. Approximate size of the Gear Rhombo is 122mm x 122mm x 116mm
Gears and Core can be printed in any material of your choice. Clips SHOULD be printed in PETG. Tool is not required for installation
For Gear Rhombo JR: This Gear fidget toy is a lot of fun and is now portable. TRY IT FOR FREE BEFORE YOU DECIDE TO BUY IT! Approximate size of this design is: 50mmx50mmx50mm.
The time to print and fully assemble is approximately 1 hour and 15-30 minutes.
Gears and core may be printed in any material. Clips should be printed in PETG. Tool can be printed in PLA.
Place the clip into the tool and use the tool to place the clips directly into the holes on the core. Make sure you go directly into the hole to avoid splitting, breaking, or over-bending the clips. I would recommend that you print out additional clips to ensure you have extras when you mess up.
Once the clips are installed, you can place the gears following the numbering located on each gear and core side.
The mechanism to move this toy fidget was inspired by RuvenBals' Gear Ball and Emmett's Gear Cube.
Enjoy!