tracking pixel
Avel

Oculus Helmet 45 Degree Mount (For use with thing:3678066)

by
triumphinglosersbusiness
Follow
Follow
Remix Model
Oculus Helmet 45 Degree Mount (For use with thing:3678066) 3d model
Oculus Helmet 45 Degree Mount (For use with thing:3678066) 3d model
2D
3D
Makes
Be the first to upload a Make
This model is restricted by licensing terms. 

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4600600.

This is a piece I designed to work with Lensfort's Oculus Rift S, Quest, CV1 Wall mount. If you print it oriented the way I've shown, with the flat side with holes down, you shouldn't need supports.

It gives you the option to mount it on a 45 degree angle/shelf. I used these M5 brass inserts from Amazon (non-affiliated) and my soldering iron to place them, but any threaded inserts with an outside diameter of around 6mm will work.

There are two here because I originally designed one to work with wood screws that had a ~7mm head, but realized afterwards that I only had wood screws with an ~8mm head, so I just uploaded both.

This is the M5 screw set I purchased from Amazon (also non-affiliated) to use with the M5 brass inserts.


0 Likes1 DownloadsApril 16, 2022


0 Likes1 DownloadsApril 16, 2022
This model is restricted by licensing terms.