tiny cat

A little furry friend that lies around like a proper lazy bum. Will also sit upright on front paws to beg for food. Printable as small as approximately 6.6 cm (65% scale) with flow multiplier and pressure advance settings dialed in. Any smaller and the paws get stuck (I already tried it!)

Files included:

• unibody STL (single part printing)
• unibody 3MF (single part multicolor printing)
• multipart STLs (separate part printing and assembly)
• multipart 3MF (multicolor separate part printing and assembly)

Print settings and recommendations:

• 3 walls at 0.4mm nozzle size
• 40-60mm/s outer wall speed recommended
• 15% infill (adaptive cubic, cross hatch, or gyroid)
• no supports, slow down for overhangs enabled
• no brim unless adhesion issues arise
• PEZ / polyurea plate highly recommended
• 65% scale tested for all models

Licensing: These model files are for your personal use only. Commercial licensing is available to sell physical prints of all tinymakery designs at patreon.com/tinymakery.