tracking pixel
San G

Huge Christmas Ornament D20 Print In Place - Hollow

by
sanglover84
Follow
Follow
Remix Model
sanglover84
sanglover84
|
Image 3 of 10
Huge Christmas Ornament D20 Print In Place - Hollow 3d model
sanglover84
sanglover84
|
Image 3 of 10
Huge Christmas Ornament D20 Print In Place - Hollow 3d model
2D
3D
Makes
Huge Christmas Ornament D20 Print In Place - Hollow 3d model
Huge Christmas Ornament D20 Print In Place - Hollow 3d model
Huge Christmas Ornament D20 Print In Place - Hollow 3d model
Huge Christmas Ornament D20 Print In Place - Hollow 3d model
Huge Christmas Ornament D20 Print In Place - Hollow 3d model
Huge Christmas Ornament D20 Print In Place - Hollow 3d model
Huge Christmas Ornament D20 Print In Place - Hollow 3d model
Huge Christmas Ornament D20 Print In Place - Hollow 3d model
Huge Christmas Ornament D20 Print In Place - Hollow 3d model
Huge Christmas Ornament D20 Print In Place - Hollow 3d model

This is a hollow D20 you can print in place and when it's done, hang up from the top (there's a 3mm hole) and fill with small things, like candy or regular sized dice.

I tried to print it a few ways and ultimately rotated it so one number was on the bottom and added a large brim. It was perfect. So weird. I didn't use supports, islands, anything. Those had resulted in about 6 fails.

I use Lychee, all I did was go to Rotate > On Plate, and then clicked one side.


0 Likes2 DownloadsNovember 10, 2024



0 Likes2 DownloadsNovember 10, 2024