This magnetic cable organizer is extremely useful where it allows magnetic attachments on your cables to connect to the magnetic base. Base can be attached to a desk, wall, or other furniture using 3M wall strips, or double sided tape.

Cable Holders should be printed in TPU or Flexible PLA. I recommend ATARAXIA ART Flexible PLA. There are other Flexible PLAs that I am sure would print well.

Base can be printed in normal PLA of your choice. Magnets are common 6mm x 2mm - super glue them in. Be sure to match your polarity so the connectors stick to the base. They should easily push into the TPU, but you will need to tap them into the base using a light hammer. I recommend using a stack of 10 or so magnets as like a nail and tap them in that way. Just a little trick I have learned.

Printing recommendations:

• Print in place no supports necessary
• .2mm layers or less is fine
• 15% or more infill is fine
• 2 or more walls is fine