Honeycomb Raspberry Pi Zero 2 W Case with Optional Extrusion Mount

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5173506.

Honeycomb Raspberry Pi Zero 2 W Case with Optional Extrusion Mount

This design is based on my case for the original Pi Zero. This case is slightly thinner than the original and is recessed more on the port access side. The bottom also has the honeycomb design for better cooling all around, The cutout for a heat sink has been resized and shifted for the new SoC (I'm using a heatsink I bought for my RPi 4 on my Zero 2 with this case).The GPIO access slot is a bit larger for easier access and the finger cutout for SD card access was extended to the bottom piece and mount.

Needs 4 M3 screws If using the extrusion mount or foot, you will need16 mm screws.

STEP file included.