mrwheezye

0

Followers

1

Following

0

Model Views

0

Downloads

0

Comments

0

Likes

Achievements

Novice Maker

First Make published

Voyager

50 Models downloaded

0

Followers

1

Following

0

Model Views

0

Downloads

0

Comments

0

Likes

Sort by:

Oddish Pot (No Supports) - Cute little Oddish planter. Scaled it up to 150% and works fine.

One tip with the eyes and mouth is to run the print then once it finishes instead of taking it off, raise the heatbed temp to 80° so the print gets a bit malleable leave it for a minute and then peel it off the print bed and press to the recesses. That then forms the eyes to the curve of the pot and they glue in a lot better.

I also just made a small circle and ran it for 5 layers with top ironing for the pupils and just glued those on. - 3d model