3D MODEL DESCRIPTION Transparent Filament Spool
Please see printing instructions
3D PRINTING SETTINGS Print Settings Printer brand: Creality
Printer: Ender-3 S1 Pro Rafts: No Supports: No Resolution: .2 Infill: 15% depending on the chosen pattern
Filament color: brown
Filament material: Wood PLA on the sides
Notes: Zero top and bottom layers, at least 10 perimeters/shells Set infill to 15% I used full honeycomb pattern for infill. Set layer height to .2mm Preview to make sure the sides are transparent . Post-Printing Place large center section on a flat surface.
Put a few drops of super glue on the flange and slide one of the side section onto the flange. Continue when set.
Slide the other side section onto the large center section.
Put a few drops of super glue on the center of the small center section and then slide the small section into the large section. Continue when set.
Flip the whole unit and put a few drop of super glue on the flange of the small section and then allow the loose side to slide down onto the small center section. Continue when set.
Do not try to use this model without gluing the parts. Enjoy.
CATEGORIES