This cube tests for a lot of basic calibration and hardware issues on an FDM printer, all at once.
You need to print this cube:-
at 0.2mm layer height on a 0.4mm nozzle (or smaller) with 0.4-0.46 line width The screw and rod parts snap off to test in the screw holes and normal holes. There are ghosting, overhang, cooling, ovality tests among other things.
This work is licensed under a Creative Commons (4.0 International License) Attribution-NonCommercial, you may not redistribute this commercially, please link to this source. You can however show it in your videos or whatever, commercial or otherwise.
Category:
77 Likes144 DownloadsJanuary 28, 2024
77 Likes144 DownloadsJanuary 28, 2024