This model was made in collaboration with Gazzaladra.
An Apple Magsafe charger tray with some extra space for everyday items
Requires:
1x Apple Magsafe Charger (last gen)
Filament Used
Instructions
- Print the parts
- Insert Bottom to tray pointing the direction you want the Magsafe face
- Screw on upper piece
- Insert the cable from above
- Press the charger into the tray
- To remove the Magsafe charger, use a wooden chopstick from the bottom!
**Sizes: **
- 240 x 240 x 100 mm
- 220 x 220 x 100 mm
Print settings Required build volume: 220 x 220 x 220 mm Material usage: 250 g
Material: PLA Print direction: STLs are rotated correctly, check images Support: Optional, tree recommended Nozzle size: 0.4 mm Line width: 0.4 mm Layer height 0.2 mm Outer walls: 3 Speed: To avoid a bad surface in the upper layers reduce speed settings Infill: 15% Build plate adhesion type: brim or raft Support: Not necessary but advised for a better fit of the charger. Tree support with a 30 degree “threshold angle”. (in Cura the number is calculated 90-30 – so put 60 in “Support overhang angle”)