Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5938490.
I have a 2nd Gen Tacoma with a 3rd Gen Tacoma windshield that has the integrated Go Pro mount location. I needed a way to mount my existing cheapie dash cam I bought from Amazon to it.
This is a remix of an existing bracket / adapter but it's been resized to fit my dash cam. The original looked right, but it was too big to fit this Crosstour model I have.
This might fit others as well!
It's a tight fit. Kind of had to force it in there. But I prefer it this way so it doesn't fall off.
I used PETG as my first design in PLA failed after a while. (it never actually fell off but it shrunk and shriveled like stepping out of a cold shower) so it became rather wobbly
The PETG should net better results against heat.
I didn't use supports but if your printer has bad overhangs and bridging, it might be worth to try and use supports. It just might be tough to remove because the spot where the support would be is pretty tight. You'll want some small needle nose pliers and really dial down your support settings so it's as minimal as possible.