Dyson Supersonsonic Dryer Attachment Holder and Magsafe Holder, MB.stl

Dyson Supersonsonic Dryer Attachment Holder and Magsafe Holder for Multiboard.

Note on Design This item provides optimal adhesion for your Dyson attachments over models that utilize magnets by matching the way the dryer and attachments go together. The magnets are in the attachments not the dryer.

For any designers out there you should notice that each attachment is made up of 24 magnets of opposing polarity (+,-,+,-,+,-,etc). This is why magnets have a poor adhesion. Some are pulling and some are pushing, this is also why you may notice that it locks position.

Printer Settings For optimal adhesion of the adhesive I would iron all top surfaces and clean them before adhesion of the magsafe ring.

Items to Print: This item holds most of the Dyson dryer attachments and utilizes a 13 mm small shank screw to attach to a Multiboard tile. The holder is intended to grab onto the screw but it isn't perfect.

https://thangs.com/designer/Keep%20Making/3d-model/13%20mm%20Small%20Thread%2C%20Flat%20Head%2C%20T-Bolt-974236

Items to Buy For the magnetic attachment I used the following but it should work as long as the ID is 46 mm and OD is 56 mm.

https://www.amazon.com/dp/B0C4QDYLX3?ref=ppx_yo2ov_dt_b_product_details&th=1