gazzaladra

Reed diffuser “sylvestris tree”

by
gazzaladra
Follow
Follow
Remix Model
gazzaladra
gazzaladra
|
Image 6 of 8
Reed diffuser “sylvestris tree” 3d model
gazzaladra
gazzaladra
|
Image 6 of 8
Reed diffuser “sylvestris tree” 3d model
2D
3D
Makes
instagram-play
Reed diffuser “sylvestris tree” 3d model
Reed diffuser “sylvestris tree” 3d model
Reed diffuser “sylvestris tree” 3d model
Reed diffuser “sylvestris tree” 3d model
Reed diffuser “sylvestris tree” 3d model
Reed diffuser “sylvestris tree” 3d model
Reed diffuser “sylvestris tree” 3d model
Reed diffuser “sylvestris tree” 3d model
This model is restricted by licensing terms. 

A reed diffuser based on a 3d scan of “pinus sylvestris” to be used with refill bags. The top and bottom align automatically with a notch.

Size assembled: 50 x 50 x 120 mm Filling volume: 100ml

Print settings Important: Please make sure that any oil that your scent may contain is okay with the material of your print. Make sure that nothing in the product might be able to dissolve your print. For me PLA works just fine.

Required build volume: 100 x 100 x 100 mm Material usage: 60 g

Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 15% Build plate adhesion type: none

Watertight printing: If you have a well set up machine it comes automatically - Otherwise here are some tips: Increase your wall count (at least 3), level your bed nicely, decrease print speed, increase layer height (at least 0.2mm), increase print temperature, check your seam quality, calibrate your e-steps and fine tune your retraction settings to make sure no holes appear after a layer change.


32 Likes52 DownloadsMarch 28, 2024


32 Likes52 DownloadsMarch 28, 2024
This model is restricted by licensing terms.