A mesmerizing pendant lamp inspired by wrapped candy. Single and multi-color printing models are included as STL and 3MF! They work with all current and usual multi color setups.
Instructions
- Check the provided images for measurements.
- Get a E26 /E27 lamp socket kit with a screw-on attachment ring and a matching LED bulb. Under no circumstances use any other light than LED due to potential heat development! You can easily get the sockets with cord and canopy on Amazon, Ikea or your local hardware store.
- Print the design in either a light color to have the light shine through the hull or in an opaque color for spot-light only appliance. Use the multi color for an extra fancy print.
- Insert the Socket (without bulb) from above and fix it in place with the ring.
- Fix the Canopy on your ceiling with the desired cord length.
- Insert the bulb.
- Enjoy your new lamp!
Size: 180 x 180 x 240 mm
Print settings Important: Do not use any other light source than LED with this Design. Depending on the strength of your LED certain parts of the print might warm up. Your filament has a certain heat deflection temperature that defines at which temperature deformation might occur. Make sure to build a safe product by verifying that the print is not affected by the amount of heat that your light source emits! If you are uncertain or have little experience in building electrified products, please consult a professional!
Usually, a strong LED bulb does not get hotter than 50 degrees Celsius while regular PLA does not deform under 58 degrees Celsius. Those are approximate numbers, and you need to verify that for your own product selection.
Required build volume: 180 x 180 x 240 mm Material usage: 350 g
Material: Filament that can handle the heat that your light source emits. Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 15% Build plate adhesion type: brim