This bundle of wall shelfs is a highly naturalistic replica of real “trametes pubescens” that I found and 3d-scanned. Include are two compositions in real life size as shelfs and each of the seven individual mushrooms to be used as extra décor.

Versions

• Trametes_pubescens_shelf_A and _B: The shelves
• Trametes_pubescens_shelf_no_holder_A and _B: The shelves without the cut-out intended for scaling down – must be mounted with glue or tape.
• Trametes_pubescens_shelf_A_large: The shelf in a bigger version to match the size of the other wall shelves.
• Trametes_pubescens_holder: the holder with a screw-hole diameter of 5.5mm
• Trametes_pubescens_holder_for_upscaling: If you want a huge version, scale up the shelf_A_large and use this holder – the only difference is the screw-hole size of 3mm that will be usable when scaled.
• Trametes_pubescens_individual_1 – 7: The mushrooms individually - must be mounted with glue or tape.

Instructions

• Print the shelf and holder
• You can either screw or glue it onto your wall. There are various glue or tape products for wall fixation out there. I used 3M Tape. Old fashioned screws and dowels are the most reliable fixation.
• Insert the shelf by moving it horizontally onto the holder until the holder is completely inside the cutout. Then proceed to move the shelf down and the holder locks.
• Enjoy!

Print settings Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 15% Build plate adhesion type: none