tracking pixel
gazzaladra

Modular drawer divider

by
gazzaladra
Follow
Follow
Remix Model
gazzaladra
gazzaladra
Image 1 of 7
Modular drawer divider 3d model
2D
3D
Makes
Modular drawer divider 3d model
Modular drawer divider 3d model
Modular drawer divider 3d model
Modular drawer divider 3d model
Modular drawer divider 3d model
Modular drawer divider 3d model
Modular drawer divider 3d model
This model is restricted by licensing terms. 
82 Likes47 DownloadsJune 5, 2023
This model is restricted by licensing terms. 


A modular drawer divider suited for many different use cases. You can configure the parts to fit your needs and drawers perfectly. The parts are fast to print and use very little material.

The connectors of the dividers can hold up to 4 parts and you can create every possible compartment composition. The connectors to not add to leigh so measuring what parts you need is quite easy.

How it works

  • Measure your drawer and make a little sketch of the size and setup of parts you want to print (I included a showcase sketch in the pictures)
  • Find out which height you want to use (either 11 or 8 cm)
  • Make a list of the parts you need (available parts can be found below)
  • Print the parts and for every connection point two of the connectors
  • Assemble the parts and connectors and place them in your drawer
  • If you have an odd size like 40.5 cm – use extra connectors at the end of your assembly to add to length below two centimeters

List of parts (height x width)

  • H8W2

  • H8W3

  • H8W4

  • H8W5

  • H8W7

  • H8W10

  • H8W15

  • H8W20

  • H11W2

  • H11W3

  • H11W4

  • H11W5

  • H11W7

  • H11W10

  • H11W15

  • H11W20

  • Universal Connector

Print settings Required build volume: depends on what part you want to print Material usage example: H8W10: 10g

This design needs a decent print bed adhesion. Depending on your bed type measures like slowing down the first layer, increasing initial layer print temperature, increasing the first layer height, cleaning the bed with isopropyl alcohol or bed leveling may help. With a generally well set up printer the design is easy to print. If nothing else helps a brim can be used.

Material: PLA Print direction: stls are rotated correctly (check images) Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 15% Build plate adhesion type: none


82 Likes47 DownloadsJune 5, 2023




This model is restricted by licensing terms. 
82 Likes47 DownloadsJune 5, 2023
This model is restricted by licensing terms.