This model was made in collaboration with Jankmart.
An Apple Magsafe charger tray with a little extra space for small items. The design comes in two different versions.
Instructions Version A Size: 216 x 216 x 20 mm Print the part Insert the cable from above Press the charger into the tray Enjoy!
Instructions Version B Choose your size: 240 x 240 x 100 or 220 x 220 x 100 mm Print the parts Insert the Bottom into the tray pointing in the direction that you want the Magsafe to face Screw on the upper piece Insert the cable from above Press the charger into the tray To remove the Magsafe charger, use a wooden chopstick from the bottom! Enjoy!
Print settings All Parts Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 15%
Only for the Tray (all versions) Speed: To avoid a bad surface in the upper layers, make sure to pay attention to your speed settings. Build plate adhesion type: brim Support: Not necessary but advised for a better fit of the charger. Tree support with a 30 degree “threshold angle”. (in Cura the number is calculated 90-30 – so put 60 in “Support overhang angle”)