A lovely suet ball holder with a roof for rain protection. Keep the little wild birds in your garden fed over the winter with this little house-inspired feeder. The roof keeps off the worst of the rain – For the rest there are drainage holes at the bottom.
Instructions
- Print all three parts
- Insert up to four balls with the usual diameter of 50 – 60 mm. 66mm is the maximum size that fits.
- Screw on the roof
- Insert the holder carefully until it snaps in place.
- Place it in a visible spot where you would expect birds to go.
- Check in on the thing occasionally to refill it. The birds here already picked quite the holes into the balls over a weekend – so maybe once a month it is time to refill it.
- Enjoy!
Size assembled: 120 x 120 x 314 mm Interior size: 66 x 66 x 205 mm
Print settings Required build volume: 130 x 130 x 210 mm Material usage: 170 g
Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 15% Build plate adhesion type: none
Categories:
102 Likes195 DownloadsDecember 20, 2023