drawing tablet wall mount meant to be slid into place on a wall with two screws already screwed into the wall. Mount was designed for Artisul D16 drawing tablet (but bigger tablets should still fit) and its regulated stand as well as the drawing pen with a hole on a left. Soft PLA doesn't scratch the tablet. I mounted mine above my middle screen. You can quickly remove tablet from the mount and start drawing. There are two semi rings on the front, you can hook some velcro straps on them to guide some cables. they are very strong. Model is pretty big. I printed mine rotated 45 degrees to snuggly fit on a 30x30cm build plate. you can scale it down a lot just make sure there is some room for the tablet to fit without too much screen scratching