Oversized Blastoise Pokemon Card - HueForge Hybrid Print

Please excuse the paint job on this one (I am hopeless when it comes to painting!)

Another HueForge Hybrid print for you - an oversized Pokemon card of Blastoise, as usual completely Print in Place with NO supports required.

This print uses 5 colours (with Teal repeated for Blastoise). If you only have one AMS, you can swap out the Black for Yellow after the Black is done printing, and make sure you assign both Black and Yellow to the same AMS slot when you send the print to the printer!

For all Bambu Studio / Bambu printers, please download the 3MF file and all the settings will have been applied for you, including the layer swaps. If you are NOT using a Bambu printer or Bambu Studio, please download the STL instead, and follow the print instructions below:

Print Instructions For the HueForge part of the print (Layer height 0.00mm to 2.60mm)

• Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm.

For the Blastoise part of the print (Layer height 2.60mm - 31.72mm)

• Print at 5% infill, with a layer height of 0.16mm, 2 wall loops, 3 tops and 3 bottom surfaces.

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4
• PLA META Sunlu Teal Transmission Distance: 5.4
• PLA BambuLab Basic BambuLab Green Transmission Distance: 8
• PLA Kingroon White Transmission Distance: 8
• PLA CC3D Lemon Yellow Transmission Distance: 8

Swap Instructions:

• Start with Black
• At 0.6mm swap to Teal
• At 0.84mm swap to BambuLab Green
• At 0.92mm swap to White
• At 1.56mm swap to Yellow
• At 2.60mm swap to Teal (for Blastoise!)

Post Processing You will need to paint Blastoise! I used paint pens to make it easier :)

I used this Blastoise model by neb1236 for this hybrid!

If you'd like to support me, I now have a Patreon!

Joining will give you behind the scenes information on WIPs, access to a private discord, early access and more!

If you want to sell any physical models I have uploaded anywhere, an unrestricted commercial license is available on the $10AUD tier of my Patreon!