Converse All Stars - Hueforge Print

A quick and simple print for the Converse sneakerheads out there! Three filament colours (2 swaps).

Note: You do not need an AMS to print this! Download the STL, and add a pause at the correct layer so that you can load in a new filament spool, and then resume the print! An AMS does really help, however!

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4

• PLA+ eSun Grey Transmission Distance: 1.4

• PLA Kingroon White Transmission Distance: 8

Swap Instructions:

• Start with Black
• At layer #9 (0.84mm) swap to Grey
• At layer #17 (1.48mm) swap to White for the rest.