This pedal is a replacement for the thumb throttle on the Logitech Extreme 3D Pro.

This a 6 part model and in addition will require 2- 8mm rods to support a step gear and the pedal . with 5mm m4 brass inserts and 14mm M4 screws

In order to wire this I used Breadboard jumper wires and just plugged them in to the wirehead clip for the throttle within the joystick. I joined long lengths of wire to these jumper cables in order to be able to use this pedal on the floor. by doing it this way the modification is reversable by simply disconnecting these. Alternatively the base wires could be cut and extended to reach the desired length but this would be less reversable.

remove the potentiometer from the throttle and place it within the pedal 

see photos for some context.

please reach out if you have questions or need some more instructions

Also see my stick extension for this same joystick cheers.
https://thangs.com/designer/cjstaleyhand/3d-model/Logitech%20extreme%203D%20pro%20stick%20extension%20-67527?manualModelView=true  

 

Logitech Extreme 3D Pro Throttle Pedal

Base.stl

Plug housing.stl

Mount for Logitech 3D pro Joystick. Adds Length to provide higher sensitivity via extra range of movement.  

This model is joined using 
M4 20mm Screws 
M4 X D6.0 X L5.0 Brass inserts

Please note that the wires housed within the joystick will need to be lengthened. I achieved this by cutting and soldering extra lengths onto the existing wires; although clips could be used.

I printed with PETG at 35% infill
but likely PLA is fine . 

It is advised to print on its side so that the layer seams run top to bottom. This will provide strength where the joystick clips on to the mount. 

Logitech extreme 3D pro stick extension 

Stick 1.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like