AllAll
Search scope
Upload for Search
AllAll
Search scope
Upload for Search
AT

Catch Tile

by
andrewtho5942
Follow
Follow
Remix Model
Social
Koz
Koz
|
|
Image 5 of 7
Catch Tile - Printed using Ionized Cobalt Black and Geomagnetic Mauve Fusion Filaments ABS 1.5. Arm is held in place using an M3x20 screw and a hex nut. - 3d model
Koz
Koz
|
|
Image 5 of 7
Catch Tile - Printed using Ionized Cobalt Black and Geomagnetic Mauve Fusion Filaments ABS 1.5. Arm is held in place using an M3x20 screw and a hex nut. - 3d model
2D
3D
Makes
Catch Tile 3d model
Catch Tile 3d model
Catch Tile 3d model
Catch Tile - Printed in Geomagnetic Mauve and Ionized Cobalt Black Fusion Filaments ABS 1.5. Uses an M3x20 screw and a hex nut to hold the arm in place. - 3d model
Catch Tile - Printed using Ionized Cobalt Black and Geomagnetic Mauve Fusion Filaments ABS 1.5. Arm is held in place using an M3x20 screw and a hex nut. - 3d model
Catch Tile 3d model
Catch Tile 3d model

This tile is still in development and is not tuned properly yet to have the exact intended effect. Print at your own risk! I will update the arm when the tuning is complete.

This is a new tile for Hextraction that I made. The idea is that balls will be stopped by the lever arm until there are enough for their weight to lift the arm and release multiple balls. If it is weighted correctly, balls with different speeds will get different behavior, which is pretty cool.

I designed the joint to use a 3mm OD x 20mm screw, but using a 3d printed cylinder that is glued into the hole could also work.

The arms will lift too easily without weight. Glue a ball to the end of the arm to add weight.

All models are scaled up 10x.

Thanks and have fun,

  • Andrew
31 Likes102 DownloadsMay 22, 2023
31 Likes102 DownloadsMay 22, 2023
TermsTerms & ConditionsSupportFeedbackReportReport ModelPrivacy