Still have plenty of room for improvement, print with caution! I may or may not come back to improve on these flaws, but you are welcome to print and try it out.

Most computer cases have a mounting for a fan at the bottom of the case. However, for my case, that was unusable after I changed to a longer power supply. So I thought why not make a bracket to let the fan mount vertically to direct more airflow to the graphics card.

I could have created or bought a 90 degrees bracket with holes and solve the problem, but wanted something that didn't need me to flip my desktop over to screw in the fan from the bottom.

Results from adding an extra fan to redirect airflow have been inconclusive so far. The catches to hook onto the fan mounting holes for a 120mm fan are a bit flimsy and the fan will lean back slightly. (which might be a good thing?)

Every new design is a learning process and I welcome feedback.

Want to buy me a coffee? https://www.buymeacoffee.com/zer0s

Clicking on my affiliate links below will give me a small kickback if you purchase something. (at no extra cost to you)

AliExpress affiliate link: https://s.click.aliexpress.com/e/_DeAZr9P

Consolidated affiliate links of other 3D printing-related items: https://wp.me/peMLu6-j

For Amazon affiliate links https://wp.me/peMLu6-2C