tracking pixel
Zack F

Gryphon "Stapler" Speedloader

by
ZackFreedman
Follow
Follow
Remix Model
ZackFreedman
ZackFreedman
|
Image 2 of 3
Gryphon "Stapler" Speedloader 3d model
ZackFreedman
ZackFreedman
|
Image 2 of 3
Gryphon "Stapler" Speedloader 3d model
2D
3D
Makes
Gryphon "Stapler" Speedloader 3d model
Gryphon "Stapler" Speedloader 3d model
Gryphon "Stapler" Speedloader 3d model

Speedily reload the Nerf Gryphon "Stapler" by Captain Slug, the high-powered blaster with a flip-open integral clip.

This blaster totally rules, but delicately lining up darts in the heat of battle is a nightmare. Perfectly deposit eight rounds at once with this lightweight, quick-printing speedloader. You can print half a dozen of these in less time than a single Talon mag.

Print one Part A and one Part B, preferably out of a material with high layer adhesion like ABS. Both sides need brims, but not supports. Once printed, just snap the two sides together.

The trade-off is that it loads one fewer dart than the clip's capacity, because of the little fingers that grip the darts. I could never fit the full ten darts in there in the first place, which is why this holds eight. I suppose you could remix the Stapler itself to have a longer mag...

Fusion 360 source: https://a360.co/3Db3d8Q


24 Likes26 DownloadsJuly 11, 2023



24 Likes26 DownloadsJuly 11, 2023