[BaBo] top lid modul

Create your BaBo organizer! A system created to store them all!

Description:

This is the BaBo top lid modul. Maximum accessibility for the tools you need most often.

BaBo organizer is a stationary, very flexible system to store your tools, spare parts and even printing plates. The design is based on the iconic look of the Bambu Lab X1 printer. The entire system uses only 1 type of screw, M3x8 countersunk screws.

Update:

(13/09/23)

• Assembly optimizations

(31/10/23)

• print profile optimizations (side panels are printed upside down to get a better top surface)

(15/01/24)

• lid reinforcement

(18/01/24)

• tighter fit of the lid
• rounded corners to avoid warping on the edges

Printing: Layer height: 0.2 Supports: Yes Brim: No Material: all

Remove the purgeline afte the start of the lid part print and do not use filament calibration!

Assembly: Follow the instructions in the picture.

• printed parts
• 14 x M3x8 countersunk screws.