We wanted a gorgeous gory set for a favorite spooky time of year. Print either the necklace, or earrings or both.

The filament shown in pics is “Blood of My Enemies” by protopasta, and it inspired the set.

Size up or down but watch the size of the post hole.

Try enabling ironing and see what you think. But we think this one is find without, we just like to put the sheet side facing out once on the ear.

You can also make a necklace or pendant for other forms of jewelry.

For the findings to make earrings or necklaces:

We like this set of hypoallergenic hooks and jump rings from Amazon: https://amzn.to/3VOPkYB

Here is a link to necklace chains if you need it: https://amzn.to/3vREu9y

I like to print at .15 layer height, with the printer slowed down a bit for the top layer.

Clean plate with IPA in between prints for better adhesion.

Wait until fully cooled to remove from plate. This set is very delicate, so please be careful removing.