tracking pixel
Thomas H

Bobblehead gnome

by
ThomasH
Follow
Follow
Remix Model
ThomasH
ThomasH
|
Image 2 of 2
Bobblehead gnome 3d model
ThomasH
ThomasH
|
Image 2 of 2
Bobblehead gnome 3d model
2D
3D
Makes
Bobblehead gnome 3d model
Bobblehead gnome 3d model
This model is restricted by licensing terms. 
9 Likes6 DownloadsDecember 15, 2022
This model is restricted by licensing terms. 


Print each part, see print instructions.

Cut away the wall from the beard with a knife.

Screw the beard into the hat. Use the help tool if the fit is tight.

Use a hair dryer/hot air gun to slowly heat up the beard while you use a hand to form it (use lowest setting). It's also possible to use warm water.

Insert the spring into the beard and then the base.

Print instructions All parts has been optimized to not need any support.

The beard is designed to be printed with a 0.2 layer height.

The beard prints better with the classic perimeter generator in prusaslicer.


9 Likes6 DownloadsDecember 15, 2022




This model is restricted by licensing terms. 
9 Likes6 DownloadsDecember 15, 2022
This model is restricted by licensing terms.