Dual Blower Fan Duct for Ender 3 V2 with E3D Revo CR Hotend

Based on the MBOT3D MK2_Rev2.0 by Ahmad Sunardi, I have designed this Dual Blower Fan Duct for E3D's RapidChange Revo CR Hotend installed on the Ender 3 V2 3D Printer.

You can install it on a Direct Drive as well as Bowden setup.

The magnetic lid allows for easy access to your hotend.

It allows for better part cooling, increased print speed and quality!

Link to Ahmad's original Design: https://grabcad.com/library/mbot3d-mk2_rev2-0-ender7-style-fan-duct-1

Bill of Materials

• E3D RapidChange Revo CR Hotend - https://geni.us/RevoCR
• E3D RapidChange Revo Brass Nozzles - https://geni.us/RevoNozzle
• M3 Threaded Inserts (6x) - https://geni.us/ThreadedInserts
• M3 Round Head Screws (various lengths) - https://geni.us/M3-Screws
• M2 Round Head Screws & Hex Nuts (4x) - https://geni.us/M2-Screws
• 4010 Radial Fans (2x) - https://geni.us/4010Fan
• 4010 Axial Fan - https://geni.us/Noctua-Fan
• 10x2mm Neodym Magnet (1x) - https://geni.us/QEHG
• 8x3mm Neodym Magnet (1x) - https://geni.us/8x3Magnet
• Shrinking Tubes - https://geni.us/ShrinkTubes

Print Settings

• Filament: PETG - https://geni.us/PETG
• Print Temp: 245 °C
• Bed Temp 70 °C
• Perimeters: 3
• Infill: 25%
• Support: Paint on supports for selected parts
• Some parts should be turned around for better printability

I am printing with a Creality CR-6 SE & Ender 3 V2

Check out my YouTube Video showing the installation process for the Creality Spider Hotend. The setup for the Revo Hotend is similar: https://youtu.be/bkkwoW-EVHs

License Type = CC BY-NC-SA (CC Attribution-NonCommercial-ShareAlike)