Baby Basilisk (Extra Long) - Articulated Snap-Flex Fidget by Mimetics3D

This featured model from Mimetics3D is part of the Thangs Presents! Welcome to 3D Printing: Deluxe Edition membership plan.

If you enjoy this model, be sure to check out other models from Mimetics3D and follow for more amazing content!

Print-In-Place, No Supports, Articulating Fidget Toy Subscribe To the Mimetics 3D Commercial Tier on Thangs for rights to sell prints of your cool new friend.

This baby basilisk just can't wait to be king of the serpents. Until then, he's content to lounge about and strike a pose for you and your friends. He's been eating up and growing extra long in prep for the holidays.

This flexible, articulated fidget toy incorporates the unique Mimetics 3D Snap-Flex joint, allowing each body segment to wiggle freely OR snap into a fixed position to maximize your fidget experience.

Snap-Flex Collection: This articulated fidget toy integrates the Mimetics 3D "Snap-Flex" joint. This allows Cold Snap to both move smoothly, mimicking the fluid motion of living creatures, AND stabilize in a firm pose, providing a premium fidgeting experience.

Each SNAP will resonate as a symphony of satisfaction to your ears, confirming your masterful manipulations.

Snap-Flex Instructions: To Lock: Push Body Segments together To Unlock: Pull Body Segments Apart

Make sure to revisit frequently for more thrilling Snap-Flex models to come. I'm eager to hear your feedback and collaborate on refining this model going forward.

Other Models: If you like this Bony Basilisk, be sure to check my other articulated models! Slick the Articulated Snake Long Bony Basilisk Articulated Pearl Dragon

This model is for personal use only. If you're interested in selling physical prints of this model, please subscribe to the Mimetics 3D Commercial Tier on Thangs.

Print Settings: 0.2mm Layer Height 3 Wall Loops 3 Top Shell Layers Brim Suggested

Suggested Material: PLA or PLA+ IMPORTANT NOTE: Silk PLA is too weak to hold up to repeated use of the Snap-Flex joint. Use silks at your own risk

No Supports, Print-In-Place at 100% scale Printing any smaller may disable the Snap-Flex joint. Printing larger than 100% will make the snap louder AND harder to pop!

These tolerances are TIGHT and you'll likely have to snap each segment a few times before it's loose enough to snap/unsnap easily. I recommend you use regular PLA or PLA+. ABS might be even better, but I haven't tried it yet.

If you print this in resin, please let me know how it turns out. I imagine you would need a more flexible/less stiff resin for it to work appropriately.