2 Likes4 DownloadsOctober 5, 2024
Instructions
Filament • 0.2mm
MaterialPLA
Layer height0.2 mm
Infill density15 %
SupportsNone
With this supermario toothbrush holder your bathroom will definitely look amazing. PS: Super combinable with my Bob-Omb soap dispenser. Both together look bombastic.
- length x width x high= 11 x 11 x 11cm
- printable in 4 stages with less support
- (cap-red, inlay cap-white, body-white, eyes-black)
- plug- in system with tongue and groove
- for assembly: a little bit of superglue is needed
Categories:
2 Likes4 DownloadsOctober 5, 2024
2 Likes4 DownloadsOctober 5, 2024
Instructions
Filament • 0.2mm
MaterialPLA
Layer height0.2 mm
Infill density15 %
SupportsNone