iLevar Electric Screwdriver Multiboard Holder

Multiboard peg clip iLevar Electric Screwdriver holder that can hold it with the outer casing. My previous model was a remix of someone else's holder and it did not fit the iLevar case well (actually, it didn't even hold the outer case, only fit the inner one).

Thus I modeled a completely new one to fit it well.

This uses the Multiboard pegs. Supports required for the pegs!

No special settings required for this (other than supports), so print it however you'd like. I printed it with the following settings:

• PLA
• .2mm layer height
• Tree supports
• Aligned seam
• Wall generator: Arachne
• Order: inner-outer-inner
• 3 walls
• 15% infill (cross-hatch)
• No brim