Wavy Coasters

3D geometry to catch drips with cork base to protect table tops.

Each coaster requires a cork base. See Amazon link below for stick-on cork coaster bases.

Holder fits 4 coasters with cork bases OR 6 coasters without bases.

Print Recommendations for Coasters

Print Material: PETG (High temperature resistance of PETG is required for this design)

Infill Percent: 8%

Infill Type: Gyroid

Top Layers: 0 (this is required to expose the infill)

Bottom Layers: 5

Perimeters: 3

Layer Height: .15

Supports: NONE

Color Change: YES. Colors are manually swapped in the included GCODE and Prusa Slicer files. Pictured design changes to a new color for the last 4 layers.

Print Recommendations for Coaster Holder

Print Material: PETG (PLA will work just fine as well)

Infill Percent: 20%

Perimeters: 2

Layer Height: .15 (higher layer heights work as well, but layers become more visible)

Supports: NONE

Cork Bases Required for each coaster

Amazon link to pre-Cut cork bases (90mm diameter 2mm height) https://a.co/d/cpaK4Vd