Floss at the ready.

Fits Glide Oral-B Floss

Print Recommendations: Print Material: PLA Infill Percent: 15% Perimeters: 2 Layer Height: .15 Supports: NONE Print Orientation: Place the Floss holder standing upright on the build plate.

Additional Parts Required: • Double Sided Tape • Amazon Link to 3M .4 inch double sided tape https://a.co/d/3n44GFr (This adhesive twists off easily and doesn't leave residue.)

Assembly: • Use a small amount of double sided tape to secure the floss mount to the wall.

Tip: You can create a wall mounted floss dispenser if you remove the floss lid (see last photo).