Hextraction Magnetic Kythera Tile

A deluxe version of the An-Tile-Kythera with an altered ruleset. Check the video to see the magnetic lock in action. Much love to Zack Freedman, please go support him by becoming a member on his Thangs page or on his Patreon!

Rules Setup: Flick the spinner until it magnetically locks. Trigger: Rotate the spinner 60 degrees. (When flicking it won't lock sometimes, spin again).

Hardware

• seven M3x12 screws
• one M3 washer
• two 6x2mm magnets

Printing Instructions

• Filament change at the start of the spinner detail for aesthetics.
• Supports required on the spinner.
• Card variations available.

Assembly Instructions

1. Glue two 6x2mm magnets into the sides of the spinner. Polarity doesn't matter. Wait until dried.
2. Install six M3x12 screws into the corners of the base.
3. Insert an M3x12 screw into the spinner then stack a washer on the end of the screw. Install the spinner. It should freely spin, barely wobble and jitter when magnetically locking. If it's grinding on the base or not jittering, back out the corner screws a little.