The Trysta - Vase Mode Pendant Light with Bambu 3MF

Vase Mode, No Supports, Quick Print Subscribe To the Mimetics 3D Commercial Tier on Thangs. for rights to sell prints

Check out a spookier pendant light here Faces of Death - Pendant Light, Vase Mode: https://than.gs/m/1046980

You cut a striking figure where the light and shadow meet. To observe from just one angle leaves the picture incomplete

The Trysta is for you

The Trysta (Tris-tuh) Pendant Light graces each room with modern elegance.

The clean, ribbed design complements a wide range of aesthetics, while the vertical pattern both hides and accentuates the curves that lie within.

What's holding you back? Rendezvous with destiny

Model Details: You can start printing this model right away on a Bambu printer using the prepared 3mf file optimized for printing this model.

This model is designed to fit this Pendant Light kit: https://www.amazon.com/dp/B0CHHVSLQ1

The Trysta represents the third design in the Mimetics3D Home Decor collection.

This model is for personal use only. If you're interested in selling physical prints of this model, please subscribe to the Mimetics 3D Commercial Tier on Thangs.

Assembly Instructions Refer to the video in the image carousel

Other Home Decor: The Hestra - Pendant Light, Vase Mode: https://than.gs/m/1042357 The Trysta - Pendant Light, Vase Mode: https://than.gs/m/1042457 The Stria - Pendant Light, Vase Mode: https://than.gs/m/1042321 The Scura - Pendant Light, Vase Mode: https://than.gs/m/1046091

Safety First Intended for use with 9 watt LED Lights
Other lights can get too hot and damage/deform the plastic

Print Settings: Vase Mode/Spiralize/Spiral Vase Mode 0.55 mm wall thickness 8 bottom shell layers Print with the circular cut-out on the build plate

100% Scale Attempting to scale this model up or down will prevent the opening from fitting the intended Pendant Light kit: https://www.amazon.com/dp/B0CHHVSLQ1

Please let me know if you would like to see other variations of this lamp.