BigTreeTech U2C Mount - CAN we do it?! Yes, we CAN!

CAN we mount this? Yes, we CAN!

Adding CAN Capabilities to your 3D Printer? Depending on what mainboard you are running you may need the BigTreeTech U2C board to interface with your CAN toolboard. This is a mount to install the BigTreeTech U2C to your 3D Printer Build.

Two versions included, one for heat press inserts (M3x4x5), and one for threading directly into the plastic.

Intended for use with 1" wide VHB tape, but could easily be scaled up or down for different cable sizes & tapes.

Parts Needed (Affiliate Links):

• VHB Tape: https://amzn.to/3VlXgy9
• M3x6 Screws: https://amzn.to/3AYdAMc
• M3 Heat Inserts: https://amzn.to/3LEMezN
• BigTreeTech U2C: http://shrsl.com/41ygp
• Polymaker Filament: https://tinyurl.com/Polymakerr

Files Included:

• BTT U2C Mounts - STEP File
• BTT U2C Mount - Heat Insert Ver.
• BTT U2C Mount - Plastic Thread Ver.

Recommended Print Settings:

• 3 Perimeters
• 20% Infill
• No Supports Required
• PLA filament is generally fine for this application. If near hot components ASA or ABS would be preferred.

Want to Support what I do? Check out my social medias please!

Link Tree: http://www.MandicReally.com/links

Design covered by GPL3 Open Source license. Any Remixes or Derivatives are required to adhere to license terms & use the same license.

PLEASE Attrubute any Remixes of my designs: MandicReally