This release includes:
🎮 Split up verison 🎮 Precolored 3MF version 🎮 Keychain with 3MF
This is a fun and quick little container to store your things, the split up version is great if you rather print and then glue together, the 3MF version of the Lid is great if you rather print it all at once.
I have made a quick youtube short of putting the split up version together. The glue i used in this was too thick and was making a bit of a mess, I recommend going with a thinner glue, the brand I used was Gorilla glue.
This model is for PERSONAL USE ONLY, if you want a commercial license and access to more awesome models you can get it on my patreon
3D printing settings The tolerance of the lid should be tight enough that the lid does not slide off once placed in, you might see that the more you use it the easier it will be to open and close, from personal experience I found that even after repetitive use, and the lid becoming looser I was able to keep it in place by pushing it tight against the top.
I don't recommend printing the lid with a brim as that might make it more difficult to slide into the container. If you are having a hard time with getting it to fit, rubbing a bit of sand paper on either side of the lid will help!