tracking pixel
Kazi T

Geared SD Card Case

by

Kazi Toad

Follow
Follow
Remix Model
Like
Kazi Toad
Kazi Toad
Image 1 of 4
SD card case in action!
Geared SD Card Case - SD card case in action! - 3d model
2D
3D
Makes
Geared SD Card Case - SD card case in action! - 3d model
Geared SD Card Case 3d model
Geared SD Card Case - Nice, though a bit loose - 3d model
Geared SD Card Case 3d model
This model is restricted by licensing terms. 
25 Likes65 DownloadsOctober 14, 2021
This model is restricted by licensing terms. 


These files are for Personal Use Only. If you would like a Commercial License to sell prints made from these designs, please join me on Patreon: https://www.patreon.com/kazitoad

Don't you hate misplacing your individual SD cards? Well now you can lose all of them at once with this tiny SD card case :)

This case features a geared hinge that provides a super smooth opening and is designed to snap into place to avoid using external components. The best part is you don't need support! Just orient the "case" with the gears pointed up and the "base" with the openings pointed up.

I am providing 4 different case models: two "4x" that hold 4 full sized SD cards (with and without magnets) and two "mixed" that hold 2 full sized SD cards and 4 micro SD cards (with and without magnets).

I suggest you print the versions with magnets. They provide the right amount of force to keep your memory cards secure and give a satisfying 'snap' that I can't stop playing with.

Printing:

For one complete card case print 2x "case" and 1x "base" of the same version. Do not use the "4x" base with the "mixed" case.

The "mag" versions are designed for 2 x 5 mm cylindrical magnets (super cheap on Aliexpress). It is a good idea to use a 2 mm drill bit (by hand) to clean the holes before super gluing the magnets in place.

Before assembly make sure the gears and hinge pins are clean (no zits or blobs). To assemble, place the two "case" parts together and pop in the "base" piece (use a C-clamp if needed).

I suggest printing in PLA at a 0.15 mm layer height or lower, 10% infill, no support, at least 3 walls, and 5 roof/floors.


25 Likes65 DownloadsOctober 14, 2021




This model is restricted by licensing terms. 
25 Likes65 DownloadsOctober 14, 2021
This model is restricted by licensing terms.