1 Likes16 DownloadsOctober 5, 2023
What is this?
Durable and long-lasting end caps for famous IGUS 16mm cable chain used in Voron Trident, Voron 2.4 and (some) Voron Switchwire builds.
Fast to print. No print supports needed.
Male and female models.
Recommended print settings:
- Layer height: 0.2mm
- Extrusion width: 0.4mm, forced
- Infill percentage: 99%, rectilinear
- Walls: 4
- Solid top/bottom layers: 5
- Supports: None
Recommended filaments:
- ASA, ASA-CF, ABS, ABS-CF
- PETG, PETG-CF will be OK for non-enclosed printers only;
- PLA, PLA-CF, PLA-tough(and alike) are not recommended due to relatively low temperature resistance.
Categories:
1 Likes16 DownloadsOctober 5, 2023
1 Likes16 DownloadsOctober 5, 2023