Filament painted print made using HueForge - Filament swaps ONLY, no mmu/ams required
5 Colour ‘filament painting’ model, Santa
(I recommend the following max speed settings, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm
Filaments Used: PLA Bambu PLA Matte Charcoal Transmission Distance: 0.6 PLA Bambu PLA Matte Marine Blue Transmission Distance: 2 PLA Bambu PLA Matte Ivory White Transmission Distance: 4 PLA Bambu PLA Matte Scarlet Red Transmission Distance: 1.5 PLA Bambu PLA Matte Lemon Yellow Transmission Distance: 3
Swap Instructions: Start with Charcoal At layer #7 (0.48mm) swap to Marine Blue At layer #9 (0.56mm) swap to Ivory White At layer #12 (0.68mm) swap to Charcoal At layer #13 (0.72mm) swap to Scarlet Red At layer #16 (0.84mm) swap to Lemon Yellow At layer #18 (0.92mm) swap to Ivory White for the rest.
I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results
Use the exact numbers in your slicer to match up properly.
The Model is designed to print with 0.4 nozzle.
If re-scaling model make sure not to alter the Z height of the model
ALL of Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.