6 Color HueForge model. Op-Art Tiger Portrait filament painting made using Sunlu and Esun Pla+ filaments.
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm
(I recommend the following speed settings for the Bambu with 0.04 layers, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)
Filaments Used: PLA Sunlu PLA+ Black Transmission Distance: 0.6 PLA Esun PLA+ Brown Transmission Distance: 1 PLA Esun PLA+ Fire Engine Red Transmission Distance: 5 PLA Esun PLA+ Orange Transmission Distance: 10 PLA Sunlu PLA+ Pure Yellow Transmission Distance: 5 PLA Sunlu PLA+ White Transmission Distance: 6
Swap Instructions: Start with Black At layer #10 (0.64mm) swap to Brown At layer #14 (0.8mm) swap to Fire Engine Red At layer #15 (0.84mm) swap to Orange At layer #19 (1mm) swap to Pure Yellow At layer #21 (1.08mm) swap to White for the rest.
This is a filament blending model, I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results.
Use the exact numbers in your slicer to match up properly.
Two different size models are supplied and designed to print with 0.4 nozzle
If Scaling the model make sure not to adjust the Z-Height of the model
ALL Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.