**PRINT INSCTURCTIONS BELOW**
The gadget seen by 9 people!
This collection not only comes with the "not patented" Doggo Stopper, but also includes the newly released BayBae Stopper!
As a **BONUS**, I've included the highly anticipated, NOT YET released BOP!!
Known by it's internal codename: _Block Of Plastic_.
These are meant to replace the 2x4s that every one has in thier place of residence, when "the gates" are installed.
_you know what i'm talking about_
**Dimensions**
Top - 37mm x 4mm
Bottom indent - 39mm x 2mm
v2 bottom flange diameter - 50mm
v3 bottom flange diameter - 60mm
Height - 54mm
I hope you all enjoy these state-of-the-art, only found here, **Treasures** that the world has provided to you.
** **PRINT INSTRUCTIONS** **
**REMEMBER:** _The use of these will put a lot of stress and pressure on the part. Please consider material type before printing._
**Recommended Material:** ABS, ABS+, ASA, Nylon, PET-G(Maybe)
**Print Settings:**
- Printed in 69% ~nice~ infill. _Remember, lots of force._
- 4 walls
- 5 Top and Bottom
I didn't use supports for the indent on the bottom. I was able to bridge that area. If you would like to use supports, the area is small. Should not be too much waste or slow to print.
** **INSTALLATION INSTRUCTIONS** **
I included pictures of the foam sticky pads I used. You know the type, by 3M. By the Command thingys.
**Matierials Needed**
- Those foam sticky pads I just talked about.
- 38mm x 5.5mm
Remove the 2x4 between your gate of choice and the wall. Place one of the choosen blocks of plastic between the gate and the wall.
**Job Complete! Congratulations!**
Have fun and print on.
Thanks for stopping by!